Inkjet Printer Forum / Ink Jet Refill ForumEverything you need to know about inkjet printers, ink jet refills, and inkjet cartridges! |
You are not logged in.
Hi all I’ve recently become the proud owner of a Primo Bravo disc duplicator, which is as I’m sure you know a combined burner and disc inkjet printer.
So I can’t the dam thing to work, the printer install goes like a dream, shows it’self ready in “PRINTERS” but the burner does not show up in “MY COMPUTER”
When I install the burning software PrimoDVD 2 it says I have No compatable burners in the system.
So I’m a bit stuck and would be grateful if anybody out has experience of these type of printers
I’ve installed it on a newly built XP SP3 Dell, standard desktop in case that’s important
Cheers
Offline
I did a quick Google search on your Disc Duplicator - not sure if it was your model though. It seems you need to connect two ports - USB for the printer and FireWire for the duplicator part. Both hooked up? If so, the duplicator driver must not have installed properly.
I copied the following from the page I got:
"Setup and software installation was a snap using the Quick setup guide. Simply hook up the USB (v1.0) cable for the printer/ robotics, FireWire cable for the CD Burner, and 12 volt DC power cable."
"Put the software CD in, and the software's auto-run guides you through the installation."
Again - don't know if this is your model and/or problem.
Steve W.
Offline